Epson XP-15000, XP-15010, XP-15080 Service Manual Page 61-90

Epson XP-15000/XP-15010/XP-15080 Revision A Disassembly/Assembly Disassembly/Reassembly Procedures 61 Confidential 7. Peel off the FFC from the APG Gear Assy, and then disconnect it from the connector on the APG Sensor. 8. Release the AC Inlet Cable from the hook on the APG Gear Assy. 9. Remove the four screws and remove the APG Gear Assy. Figure 2-30. Removing the APG Gear Assy When removing the APG Gear Assy, be careful not to drop the Spur Gear 21.6 from the IS Drive Assy. APG Gear Assy C.B.P-TITE SCREW 3x10 F/ZN-3C(6±1kgf cm) C.B.S-TITE SCREW 3x6 F/ZN-3C(8±1kgf cm) APG Sensor AC Inlet Cable Hook 1. Before installing the APG Gear Assy, rotate the APG Cam Gear 17.6 to PG- (with the rib on the gear pointing upward). Install the APG Gear Assy by following the procedure below. Figure 2-31. Installing the APG Gear Assy (1) 2. Align the triangles on the Spur Gear (black) and the Spur Gear (white) on the back side of the APG Gear Assy. Figure 2-32. Installing the APG Gear Assy (2) APG Cam Gear 17.6 Rib Right Rib on the gear pointing upward Spur Gear (black) Back side of APG Gear Assy Spur Gear (white) Align
Page 1 of 30

Epson XP-15000 Service Manual Page 61-90
Epson XP-15010 Service Manual Page 61-90
Epson XP-15080 Service Manual Page 61-90