EPSON WF-4830, WF-4820 Series Service Manual Page 121-140

EPSON WF-4830 Series/WF-4820 Series Revision A Disassembly/Assmebly Disassembly/Reassembly Procedures 121 Confidential 13. Remove the two screws that secure the Holder Duct Waste Ink, and tilt the Holder Duct Waste Ink as shown below. 14. Disconnect the Waste Ink Tube from the Holder Duct Waste Ink. Figure 3-43. 15. Remove the four screws, and remove the Ink System Unit. Figure 3-44. C.B.P-TITE SCREW,3X10,F/ZN-3C (6 ± 1 kgf cm) Holder Duct Waste Ink Waste Ink Tube Holder Duct Waste Ink Be careful not to damage the FFCs/cables when removing the Ink System Unit. C.B.P-TITE SCREW,3X10,F/ZN-3C (6 ± 1 kgf cm) Ink System Unit
Page 1 of 20

Epson WF-4830 Series Service Manual Page 121-140
Epson WF-4820 Series Service Manual Page 121-140