Epson P5000,4900,4910 service manual Page 251-300

SC-P5000 Series/Epson Stylus Pro 4900/4910 Revision G DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 251 SE Group Confidential (Related Staff Only) 3.4.7.4 Roll Feeding Motor Assy 1. Remove the Right Roll Cover. (p177) 2. Remove the SUB-D Board. (p191) 3. Remove the “HOLDER,ROLLER,RIGHT”. ( Step 3 to Step 8 in "3.4.7.2 Roll Lock Sensor" (P. 248) ) 4. Remove the Motor Assy. ( Step 4 to Step 6 in "3.4.7.3 ATC Motor Assy" (P. 250) ) 5. Disconnect the connector from the Roll Feeding Motor Assy. 6. Remove the planetary gear. 7. Remove the two screws that secure the Roll Feeding Motor Assy, and remove the Roll Feeding Motor Assy. A) Silver, Phillips, Pan machine screw M2.6x4: two pieces Figure 3-160. Removing the Roll Feeding Motor Assy When installing the planetary gear, be careful of the installation direction referring to Figure 3-160 . When installing the Roll Feeding Motor Assy, be careful of the installation direction referring to Figure 3-160 . Be sure to refer to Chapter 4 “Adjustment” (see p312) and perform specified adjustment after replacing the Roll Feeding Motor Assy. <Adjustment item> Counter Reset (Roll Feeding Motor Counter) Roll Feeding Motor Assy A A Connector Planetary gear
Page 1 of 50

Epson SC-P5000 Series Service Repair Manual Page 251-300
Epson Stylus Photo Pro4900 Service Repair Manual Page 251-300
Epson Stylus Photo Pro4910 Service Repair Manual Page 251-300

Leave a Reply